Documentation
Descrição
A high precision digital gage for quick and accurate measurement of the countersink depth. The· SR901 depth Gage has a radius type probe that contacts the inside wall of the countersink (see detail). The radius probe is designed to contact the bottom area of the countersink and can check a wide range of countersunk holes for virtually any flush head fastener - limited only by the hole diameter through. This gage can be used to set drill cages or micro-stops. The countersink angle can be calculated by using the SR901 Countersink Depth Gage in conjunction with the SR900 or SR902 Countersink Diameter Gage.
Features:
- Measuring accuracy .0001 inch (.0025mm)
- Direct contact inside the countersink walls.
- Direct reading, no calculations or charts necessary.
- Large base configurations are available for curved surfaces.
- Accurate, repeatable, and reproducible.
- SPC ready via data port cable.
- Ease of use with minimal training.
- Eliminate costly rework.
- Gage and set block calibrated to NIST traceable standards.
- Unique serial numbers on gages, set blocks, and indicators.
- The components of our gages are made of heat-treated wear-resistant tool steels and micro-finished to ensure accurate and trouble-free operation.
Digital Indicators Features:
- LCD display with rotating bezel.
- Inch/ mm mode toggle capable.
- SPC data output ready via the data port.
- Upper and lower tolerance capable.
- User-selectable resolution (Mahr-Federal).
- Auto power off after 15 minutes of inactivity (Mahr-Federal).
- Lockout of setup preset (access key- Mahr-Federal, computer -Mitutoyo)
- Choice of indicators: Mahr-Federal, Mitutoyo, or Sylvac (please advise of your preference).
Trulok® gages are built to your exact specifications. Please supply us with the following data needed for the calibration set block that will accompany the gage:
- "A" Countersink included angle:
- "B" Hole diameter through:
- "C" Countersink major diameter:
- "D" Depth of the countersink:
- "R" Transition radius:
- Fastener part number and/or specification:
- Surface curvature:
- Size, thickness, and position of any drilling jig or fixture to measure through: